Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterGate Realignment in Henderson, NV
A misaligned gate is one that no longer sits square in its frame. The latch misses the strike plate, the gate drags across the concrete, or the hinges carry weight they were never meant to hold. Gate realignment in Henderson typically costs between $145 and $320 for most standard swing gates, and Latch and Post Gate Repair Henderson can usually have it done the same day you call. We’re a Cedarwell-family gate specialist, not a general handyman, and we’ve been focused exclusively on gates since 2009.
If your gate is sagging, scraping, or refusing to latch, this page will tell you exactly what’s involved, what it costs, and how we work inside your home. It’s part of our broader Gate Repair service, and if you’d rather just talk it through, call (775) 210-7739. A live person answers, any hour, any day.
When You Need Gate Realignment
Some gates fail suddenly. Most drift out of alignment slowly, over months or years, and homeowners don’t notice until the latch stops catching or the gate starts grinding against the walkway. Here are the most common signs we see across Henderson:
- The gate drags on the ground. In Green Valley Ranch and Anthem, concrete settlement is common, and a gate that scrapes usually means the post has shifted or the hinge screws have loosened in the wood.
- The latch no longer lines up. You lift the handle, and the bolt hits the plate an inch too high or too low. This is the most frequent complaint we hear in Inspirada and MacDonald Ranch, where wind loads on larger gates slowly pull the hinges out of square.
- The gate swings open on its own. A gate that won’t stay shut usually isn’t a latch problem. It’s a gravity problem, and realigning the hinges fixes it so the gate rests where it belongs instead of drifting toward the driveway.
- You can see a gap at the top or bottom hinge. If the gap is wider at one end than the other, the gate is twisting. In Henderson’s summer heat, wood expands and contracts far more than the hardware does, and that movement loosens hinge screws over time.
- The gate bangs shut harder than it used to. Alignment shifts change how the gate travels, and a gate that slams is a gate that’s fighting its own hinges. Left alone, it’ll wear out the hinge pins and eventually crack the post.
If you’re noticing any of these, it’s worth a call. Alignment issues tend to accelerate once they start because the weight of the gate keeps working against whatever is still holding.
Our Gate Realignment Process
Every gate comes down to two parts – the latch that holds it and the post that carries it. That’s the job we focus on. Here’s how a realignment visit unfolds when you call Latch and Post Gate Repair Henderson:
- We listen first. You describe what the gate is doing, and we ask about when it started, whether it’s worse at certain times of day, and what kind of gate you have. That conversation tells us whether we’re looking at hinge wear, post movement, or frame trouble before we’ve even opened the truck.
- We inspect the hardware and the post. We check the hinge thickness, the screw depth, the post plumb, and the latch alignment. On a LiftMaster or Linear automated gate, we also check how the opener arm connects to the gate, because an opener that’s fighting a misaligned gate will burn out its gears far sooner than it should.
- We give you a written price before any work starts. No estimate range, no “we’ll see once we start.” You get a specific number on paper, and you decide. There’s no pressure to accept and no charge if you want to think about it.
- We realign and secure. That usually means resetting the gate on its hinges, tightening or replacing hinge screws, shimming where the post has settled, and adjusting the latch so the bolt slides cleanly into the strike. On automated gates, we also reset the opener’s travel limits so the motor isn’t straining.
- We test it with you. We open and close the gate a dozen times with you watching. We want you to feel the difference, not just take our word for it. If it’s an automated gate, we run a full cycle with the remote and with the keypad.
- We clean up and show you. We lay drop cloths on the floor and put on shoe covers before we step inside. When we’re done, we take a photo of the clean-up and show you before we leave. That’s the Cedarwell C.A.R.E. routine: clean up like it’s our own home, ask before we move or touch anything, respect your time and quiet hours, and explain the price before the work.
Gate Realignment Pricing in Henderson
Most gate realignment work in Henderson lands between $145 and $320, depending on what’s actually out of place. A simple latch adjustment with tightened hinges runs at the lower end. A gate that needs hinge replacement, post shimming, and opener travel reset runs higher. Here’s what we see most often:
| Service | Typical Range in Henderson |
|---|---|
| Latch realignment and hinge tightening | $145 – $210 |
| Hinge replacement (standard swing gate) | $195 – $285 |
| Post shimming and gate reset | $220 – $320 |
| Automated gate realignment with opener travel reset | $240 – $360 |
What affects the price most is the condition of the hinges and the post itself. A hinge that’s simply loose is quick to correct. A hinge that’s worn thin or a post that’s shifted in the soil takes longer to set right. If the wood around the hinge screws has rotted or split, that’s a hinge and post repair rather than realignment, and we’ll tell you that plainly before any work begins.
Every job we do carries the 365-Day Done Right Promise. If the gate drifts out of alignment again within a year of our repair, we come back and make it right. No argument, no fine print. You also get a written price before work starts on every single visit. Call (775) 210-7739 and we’ll give you a free estimate over the phone, then confirm it in writing at your door.
FAQs – Gate Realignment
How much does gate realignment cost in Henderson?
Gate realignment in Henderson usually costs between $145 and $320 for standard swing gates. The exact figure depends on whether it’s a simple latch adjustment or a full hinge replacement with post shimming. You’ll see your specific number in writing before we touch anything, and the estimate is free. Call (775) 210-7739 for an exact quote.
Can you realign an electric gate without damaging the opener?
Yes. When we realign an automated gate, we disconnect the opener, reset the gate on its hinges, then reconnect and recalibrate the travel limits on brands like LiftMaster, FAAC, BFT, and Linear. That sequence protects the opener’s gears from fighting an out-of-square gate. Most electric gate realignments in Henderson run between $240 and $360.
Why does my gate keep sagging after I tighten the hinges?
If a gate sags again weeks after tightening the hinge screws, the screws are likely stripping the wood or the post itself is moving. In Henderson’s dry climate and clay soil, posts shift seasonally, and tightening the same screws repeatedly won’t hold. We can assess whether you need longer screws, shims, or a post reset, and we’ll show you the issue before we propose the fix.
How fast can you realign my gate?
Most standard gate realignments near me in Henderson are done the same day you call, and many take under two hours. If you need it done today, call (775) 210-7739. A live person answers around the clock, and we’ll tell you honestly whether same-day service is possible for your part of town.
Why Henderson Homeowners Call Latch and Post for Gate Realignment
Most gate companies can tighten a hinge. Few will lay drop cloths on your hallway, put on shoe covers before stepping inside, and hand you a photo of the clean-up before they leave. That’s the Cedarwell C.A.R.E. routine, and it’s not an upsell. It’s how every visit works, every time.
Our technicians are background-checked and uniformed, factory-trained on the brands families in Henderson actually own, including LiftMaster, FAAC, BFT, and Linear. We choose pet-safe lubricants where there’s a choice, and we can schedule around nap time if quiet matters. If a child is asleep and the gate is on the other side of the house, we’ll use quiet tools or come back when it works for your family. You can read more about what we do on our Gate Repair in Henderson page.
Our team has been part of the Cedarwell family of independently owned and operated gate specialists since 2009. That’s fifteen-plus years of gates, latches, posts, and openers in southern Nevada, and the experience shows in how we diagnose. We don’t guess. We look, we measure, we show you what’s wrong, and we fix it right the first visit.
If your gate is dragging, banging, or refusing to latch, call (775) 210-7739. We’ll answer live, listen to what’s happening, and give you a straight answer on price before we ever knock on your door. And if you’d rather look around first, start at our home page to see the full range of what we handle in Henderson.
Written by Cody Beckman, Owner at Latch and Post Gate Repair Henderson, serving Henderson.