Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHinge & Post Repair in Henderson, NV
A sagging gate or a latch that won’t catch usually comes down to two things: the hinge that carries the weight and the post that holds everything square. Hinge and post repair in Henderson typically runs between $140 and $420 depending on how far the post has shifted and whether the hinge hardware needs full replacement, and most jobs are finished the same day we arrive. Latch and Post Gate Repair Henderson focuses on exactly this kind of work, because every gate in this valley, whether it faces Aliante’s dry afternoon heat or a Green Valley backyard, eventually fights the same physics: weight, wind, and ground that shifts with irrigation cycles. When your gate drags against the concrete or swings past the latch instead of meeting it, call us at (775) 210-7739 and we’ll give you a straight answer before we touch a single bolt.
We’re part of the Cedarwell family of independently owned and operated gate specialists, and this page covers what hinge and post repair actually involves here in Henderson. If you want the broader picture of how we handle gate work across the city, start with our Gate Repair in Henderson page.
When You Need Hinge & Post Repair
Most homeowners notice the symptom before they understand the cause. The gate scrapes. The latch misses. The top corner of the gate leans away from the post like it’s tired. Here’s what we typically see when we pull up to homes in Henderson:
- The gate drags a crescent mark into the concrete or pavers. That’s almost always hinge wear: the barrel has elongated, or the post has leaned under the gate’s weight. In neighborhoods with expansive clay soil like parts of Whitney Ranch and MacDonald Highlands, post lean gets worse after heavy irrigation seasons.
- The latch no longer lines up with the strike plate. When a post shifts even half an inch, the geometry changes. You’ll see the latch land above or below the catch, especially on hot afternoons when metal expands.
- The gate sags visibly at the far corner. A worn hinge pin or a loose hinge leaf lets gravity win. Driveway gates with ornamental steel frames hide this until the pull side starts grinding.
- The post wobbles when you push on it. If the post moves, the gate will never hold adjustment. This is the single biggest reason temporary latch fixes fail within weeks in Henderson’s wind corridors, particularly near the McCullough Range foothills.
- You hear a metal-on-metal groan every time the gate cycles. Dry, worn hinge bearings or seized hinge pins squeal under load. Electric openers pushing against that resistance burn through limit switches faster than they should.
- The gate swings open or shut on its own. A post that’s out of plumb turns gravity into an unintended opener. This matters most if you have kids or dogs who treat the gate as the boundary line.
If any of these sound familiar, the fix is rarely just tightening a bolt. It’s re-establishing the post’s position and replacing or rebuilding the hinge so the gate hangs true. That’s the gate repair work we do.
Our Hinge & Post Repair Process
Here’s how a hinge and post repair unfolds when Latch and Post Gate Repair Henderson comes out, step by step, so you know exactly what to expect before you call (775) 210-7739:
- We arrive, walk the gate with you, and take measurements. Before we write anything down, we check the post plumb in two directions with a level, examine each hinge leaf and pin for wear, and watch the gate cycle if it’s automated. We explain what we’re seeing in plain terms.
- You get a written price before any work starts. No verbal “rough guess” that changes later. The number covers the post stabilization, the hinge work, and any adjustment to the latch alignment so the gate catches clean.
- We protect the work area. If the repair touches your paver walkway or finished concrete, we lay drop cloths where tools and hardware sit. Our technicians wear shoe covers whenever we step inside your home, and we follow the Cedarwell C.A.R.E. values on every visit: clean up like it’s our own home, ask before we move or touch anything, respect your family’s time and quiet hours, and explain the price before the work.
- We stabilize the post first. That means digging out the rotted or shifted footing where necessary, re-setting the post plumb and square, and letting the new concrete or compacted base set before we hang weight on it. In Henderson’s sandy, fast-draining soil, especially in older parts of the city like Pittman, we see posts set in shallow footings that were never adequate for a 200-pound gate.
- We install or rebuild the hinges to match the gate’s weight and swing. Worn hinge pins get replaced. Loose hinge leaves get re-anchored or upgraded. If we’re working on automated gates from brands like LiftMaster, FAAC, BFT, or Linear, we set the hinge geometry so the opener isn’t fighting misalignment.
- We cycle-test the gate and walk you through the result. The gate should swing easily by hand, stop where it’s supposed to, and latch without you having to lift or shove it. Before we leave, we photograph the clean-up so you have a record of the condition we left the area in. Then we’re gone, and you don’t think about the gate again until you use it and it feels right.
Hinge & Post Repair Pricing in Henderson
Hinge and post repair pricing in Henderson usually falls into three bands, and the difference comes down to how much of the support structure is still sound:
- Hinge replacement with post in good condition: $140 to $260. We replace worn pins, rebuild or swap hinge leaves, and re-align the latch. Typical for standard residential walk gates.
- Post re-setting with hinge service: $260 to $380. The post gets dug out and re-plumbed, new concrete or gravel base set, hinges checked and adjusted once everything’s square. Most common on driveway gates.
- Full post replacement plus hinge rebuild: $380 to $650. The old post is rotted, cracked, or undersized. We set a new post, transfer the gate, hang it with new or rebuilt hinges, and tune the latch and closer. This also applies when we’re replacing a steel post in a block wall pier.
What moves the number: post material (steel versus wood versus concrete-encased), gate weight and width, whether the ground has to be cut out around existing concrete, and whether we’re reusing hardware or installing new. You’ll see the exact dollar figure in writing before we begin, and there’s no charge to come out and tell you what the gate needs. Estimates are free.
If the gate has an opener on it, expect the automatic gate repair to include a cycle-test and opener limit adjustment so the new hinge geometry doesn’t shorten the motor’s life. We service and install gates built around LiftMaster, FAAC, BFT, and Linear equipment, and we carry the parts that match what’s already on your fence line.
Why Hinge & Post Repair Matters More Than It Looks Like
A gate that hangs crooked is a gate that’s wearing out everything attached to it. The latch. The opener. The frame welds. In Henderson’s climate, with summer highs pushing well past 100 degrees and overnight lows dropping thirty degrees back, metal expands and contracts in a daily cycle. A properly hung gate absorbs that movement through the hinge. A misaligned gate concentrates it into the latch and the motor.
That’s the core of the work we do at Latch and Post Gate Repair Henderson. Every gate comes down to two parts: the latch that holds it and the post that carries it. That’s the job we focus on. When those two parts are right, the rest of the gate works the way it was built to.
FAQs – Hinge & Post Repair
How much does hinge and post repair cost in Henderson?
Hinge and post repair in Henderson typically costs between $140 and $650, with most standard jobs landing between $260 and $380. The spread depends on whether the post can be re-set or needs full replacement and whether hinge hardware is rebuilt or swapped. Call (775) 210-7739 and we’ll give you a written quote after a free on-site assessment.
Can you fix a sagging gate the same day in Henderson?
Yes, most hinge and post repairs are completed the same day we arrive, provided the post footing doesn’t need extended curing time. We carry common hinge hardware, pins, and post materials for standard residential gates, and we’re familiar with the gate styles in Henderson neighborhoods like Anthem, Inspirada, and the older streets around Water Street. Call (775) 210-7739 to schedule.
Is it cheaper to repair a leaning gate post or replace the whole gate?
Repairing or re-setting the post is almost always cheaper than replacing the entire gate, often by $500 to $2,000 depending on gate size and material. A leaning post doesn’t mean the gate itself is ruined; it means the foundation under the post has failed. We’ll tell you honestly if the gate itself is worth saving before we recommend any work.
What causes gate posts to lean in Henderson?
In Henderson, gate posts lean most often because of shallow footings, soil that shifts with irrigation cycles, and sustained wind load against wide driveway gates. The region’s sandy, fast-draining soil doesn’t hold moisture like denser clay, which means footings that weren’t dug deep enough loosen over time. We set posts deeper and wider than the original spec when we rebuild.
Do you work on gates with LiftMaster or FAAC openers?
Yes, our technicians are factory-trained on LiftMaster, FAAC, BFT, and Linear systems, and hinge and post work on an automated gate always includes recalibrating the opener limits and force settings. The gate should never fight the motor. Call (775) 210-7739 for a free estimate on your electric gate repair.
Call for a Free Hinge & Post Repair Estimate in Henderson
If your gate is scraping, sagging, or swinging past the latch, call Latch and Post Gate Repair Henderson at (775) 210-7739. A live person answers every call, any hour, any day. We’ll schedule a visit, give you a written price before any work begins, and leave your property the way we found it, minus the broken gate. Every repair carries the 365-Day Done Right Promise: if it’s not right, we make it right, no argument, no fine print.
Written by Cody Beckman, Owner at Latch and Post Gate Repair Henderson, serving Henderson.